Installation SEC Single Fuse Connector Kit
1. |
Select segment size a minimum of 5/64” smaller than outside dimensions of conductors to be installed. Cut segment to be used at cutting ring, if necessary, with sharp knife (See illustration for cutting ring dimensions) |
2. |
Apply silicone lubricant on conductor and segment opening. Conductor must be clean and free of foreign materials. |
3. |
Insert conductors through opening of segments approximately six inches beyond end of conductor kit. |
4. |
Trim insulation from conductors the length of lug on fuse holder and attach to lug. Tighten lug assembly according to inch pound chart. |
SEC Single Fused Connector Kit
5. |
Apply silicone lubricant to inside of segment around conductors. |
6. |
Using dowel provided, push fuse holder and conductor back into connector body. |
7. |
Install midget fuse and plug connector kit bodies together . SEC single fused connector kits will provide a waterproof connection that can be disconnected and reused. |
SEC Single Fused Connector Kit